Sanipack® Macerator Pump, 17 gpm, 1-1/2 in Inlet, 1/2 hp

The SANIPACK® is a macerator device which is meant to be installed inside a wall cavity. The SANIPACK® is a system that is used to install a complete bathroom up to 15 ft below the sewer line or even up to 150 ft away from a soil stack. It can handle the effluent from a toilet, sink and shower. The SANIPACK® is simplicity itself to install, there are just four connections - the macerator/pump is connected to the discharge pipe coming from a wall hung toilet, the toilet tank is connected to the water supply, The macerator/pump is connected to the small diameter discharge pipe work, the macerator/pump is connected to the electrical supply. The inside of the SANIPACK® is comprised of a pressure chamber, which starts and stops the unit and the motor, which drives the stainless steel macerator blades and the pump. When the flush is activated, the water flowing into the SANIPACK® activates a micro switch in the pressure chamber which in turn starts the motor. The motor is sealed for life in an oil filled enclosure. A common spindle/shaft drives the impeller and the macerator blades. The moving parts therefore are kept to an absolute minimum. Water and organic waste matter enter the chamber and are reduced to slurry as the macerator blades rotate at 3600 rpm. The centrifugal force causes the reduced solids to be ejected through a grill into the container where it is picked up by the impeller pump mounted beneath the motor. The unit pumps the effluent upward to 15 ft and/or 150 ft horizontally (with gravity fall). Once the water is discharged and the water level in the container goes down, the micro switch deactivates the unit until the flush is activated again. A normal operating cycle for SANIPACK® takes about 7-9 s depending upon the discharge pipe run configuration, power consumption is therefore minimal. In addition to the toilet waste, the SANIPACK® will also discharge gray water from a variety of other sanitary fixtures such as - a sink, a shower and a urinal. When adding a shower, a base will have to be construct

3 Years Limited

ASME A112.3.4|cCSAus Certified|CSA C22.2|IAPMO Listed|UL 788|UPC Listed