Gas Flex, 3/4 in ID, 3/4 in, MNPT x FNPT, 18 in L

41-4142-18

Commercial, Residential Boilers, Gas Meter, Furnaces, Commercial Water Heaters, Gas packs/Rooftop HVAC units, Tankless Water Heater, Stationary Standby Generators

Dormont®

CONNECTOR APPLIANCE GAS 3/4IN 18IN DOM

Durable and corrosion resistant|Brass or plated steel flare nuts|Brass or plated steel adapters|100% factory leak tested|Exclusive No-Neck® design increases flexibility|More corrugations per inch increase flexibility and extend service life|When installing a new appliance or when an existing appliance is moved to a new location a NEW gas connector must be per manufacturer's installation instructions and product standards|Designed for occasional movement after installation|Repeated bending, flexing or extreme vibration must be avoided|Eliminates the need for pipe nipples, 90's and elbows|Pre-fabricated gas connector means no field threading, cutting or assembly of CSST fitting and tubing|Approved for indoor/outdoor use with stationary gas appliances/equipment

Watts Water Technologies

0240937

H: 18 in x W: 1.44 in x L: 1.44 in

ANSI Z21.24/CSA 6.10 - Connectors for Gas Appliances|ANSI Z21.75/CSA 6.27 - Connectors for Outdoor Appliances and Manufactured Homes|City of New York - MEA #376-92-M|Approved by the Commonwealth of Massachusetts Board of State Examiners of Plumbers and Gas Fitters|IAPMO Listed|PROP65: This product can expose you to chemicals including lead which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov

Gas Flexes